Fighting with computers

In order to get my new 4k display connected to my Linux box at work I had to replace the graphics card (actually I was replacing none but the motherboard's one). For the 3840x2160 resolution I selected a cheap ATI board that apparently had decent Linux support, the $100 board RX460. First problem was my computer did show nothing on the new screen, that was fixed connecting the old one and using the BIOS to switch default video to the new card. Then Ubuntu 14.04 would boot but failed to recognize the new card, which makes sense as the driver was not install. However I would get graphics working using the software rendered (frame buffer). When looking for the Linux drivers I realized I would need to upgrade to Ubuntu 16.04, something I wanted to do for a while but kept leaving for a rainy day. One colleague at work mentioned to me he have had quite a good experiencing upgrading a couple of systems from 14.04 to 16.04 so I was set to do it then, now that it was supposed to be easy

Like train spotting, bird watching, I guess that wifi watching could become a thing, or so could be if you use this nice app for your Android phone. I avoid the term wardriving because it assumes you drive a vehicle and it has a dubious or evil aim (or may be that is only my interpretation). I was touched by the work of these artists that visited and gave a talk at our campus a year ago. So I just went out for running an errand and grabbed nearly 900 different SSIDs around the block. The Wifi Collector app will grab both access point information plus geographical location using the phone location services. Data can later be exported as a CSV file or KML file to be used with Google Earth as the image here shows. While I did not uncover any political message or funny stuff on the SSIDs names on the surroundings, I guess it can be another way of catching and reviewing your walks (runs?) around the city.  I will use this app more than once just for a new way of perceiving the city

One dry winter day I noticed a spark jumped from my finger when toughing the metal plate of a Printrbot Simple metal printer. Next time I tried to use that printer the hot-end would ram into the print bed so I had to stop the printer immediately. I remembered the spark incident and I assumed damage was done due to that static discharge. On to find a solution. Printrbot forums showed several entries about damaged sensors and how to replace them. Others had to replace both the inductive proximity sensor plus the Printrboad control electronics too. But one thing I noticed is that my inductive sensor was apparently working, as the LED will lit when approaching a metal part to it. After testing with M119 command, I realized that as odd as it might seem, now my printer thought the signal on Z-MIN end-stop was reversed. So it was triggered when the LED was off and open when the LED was lit. That was pretty odd but as the sensor seemed to be working I set my path to modify the firmware confi